Gme TX2720 Manuale Utente Scaricare il pdf (Pagina 8)

PAGE 8 INSTRUCTION MANUAL TX2720

INSTALLATION

The TX2720 is supplied with a DIN mounting

bracket for mounting into a standard DIN sized

cavity in the vehicle’s console or dashboard.

Before installing the radio, ensure the DC cable

and antenna have been installed correctly (as

described further below) and the connectors are

accessible through the DIN cavity.

INSTALLING THE DIN MOUNT

To install the DIN mount you will need access to

the rear of the vehicle’s console.

1. Remove the four small front mounting bolts

from the front edges of the DIN mount

and separate the front frame from the DIN

surround.

2. Slide the DIN surround into the DIN slot in the

vehicle’s console and secure it in the desired

position by bending the folding tabs.

3. Slide the TX2720 radio into the front frame so

that the threaded holes in the chassis line up

with the holes in the front frame.

4. Secure the radio using the four 8 mm bolts

and washers provided.

5. Connect the DC connector and PL259 antenna

(andrearmicrophoneextensionleadifused)

to the sockets on the radio’s rear panel.

6. Slide the front frame back into the DIN

surround and secure it using the four small

front mounting bolts.

You can now reﬁt the console to the vehicle.

DC POWER CONNECTIONS

The TX2720 is designed for 13.8 V DC negative

earth installations only (i.e. where the negative

side of the battery is connected to the frame

or chassis of the vehicle). There are two

recommended methods of installation. Please

refer to the following diagrams.

Radio remains On when the Ignition

switch is Off

Connect the radio’s negative (Black) lead to

the vehicle’s chassis or if preferred directly to

the battery’s negative terminal. Connect the

radio’s positive (Red) lead, via the 2 amp fuse,

to the battery’s positive terminal or to a point in

thefuseboxthathas+13.8voltscontinuously

available.

The radio can now be switched ON or OFF at any

time using the switch on the volume control.

Radio Turns On and Off with the Ignition

switch

Connect the radio’s negative (Black) lead to the

vehicle’s chassis or if preferred directly to the

battery’s negative terminal. Connect the radio’s

positive (Red) lead, via the 2 amp fuse, to the

accessorypointinthefusebox.Thispointshould

Radio remains ON when ignition switch is OFF

RED

Fuse

Fuse

BLACK

Chassis

Car battery

Ingnition Switch

Radio turns ON and OFF with ignition switch

RED

BLACK

Chassis

Car battery

Ingnition Switch

To Radio

To Radio

DIN Surround

Folding Tabs

Front Mounting

Bolts

Front Frame

8 mm Bolts

and Washers

Front Frame

1 2 3 4 5 6 7 8 9 10 11 12

Commenti su questo manuale

Nessun commento